Influence of pH on hygral expansion, relaxation shrinkage and extensibility of wool fabric

The standard tests for relaxation shrinkage and hygral expansion of wool fabric take no account of pH. It is shown in this work that the pH of the solution in which wool fabric is relaxed as part of the procedure for measuring dimensional properties has a significant influence on the results. At around pH 4.8, which is close to the isoelectric point of wool, the hygral expansion reaches its greatest value and drops at both lower and higher pHs. A similar relationship between pH and extensibility of wool fabric was observed. Values of relaxation shrinkage were found to be dependant on pH. The reasons for the pH dependence of dimensional properties are discussed and these include changes in wool fiber swelling, yarn crimp and polymer relaxation phenomena with changes in pH.

Copper/zinc superoxide dismutase is phosphorylated and modulated specifically by granulocyte-colony stimulating factor in myeloid cells.

Using two-dimensional sodium dodecyl sulfate polyacrylamide gel electrophoresis (2-D SDS-PAGE) of 32P-labeled cytosolic and membrane extracts, we identified a 21.5 kDa phosphoprotein with an isoelectric point of 6.0 in NFS-60 cells that was phosphorylated maximally at 15 min by treatment with granulocyte-colony stimulating factor (G-CSF) but not with interlevkin-3 (IL-3) or colony-stimulating factor-1 (macrophage-colony stimulating factor (CSF-1 (M-CSF)). The phosphorylation of this protein, designated 21.5/6.0, was unaffected by a series of antiproliferative agents [32]. These findings suggested that the 21.5/6.0 phosphoprotein may be involved in specific G-CSF-mediated biological responses such as activation and/or differentiation. We sought to characterize this 21.5/6.0 by a novel combination of 2-D SDS-PAGE and hydroxyapatite (HTP)-chromatography. Amino acid sequence determination of 21.5/6.0 revealed it to share a high level of homology with copper/zinc superoxide dismutase (Cu/Zn-SOD), indicating that a Cu/Zn-SOD is phosphorylated following treatment with G-CSF. This is the first report of the phosphorylation and possible involvement of Cu/Zn-SOD protein in granulocyte activation/differentiation events. In addition, Cu/Zn-SOD levels and activity were diminished by G-CSF but not IL-3 treatment. This new protocol combining 2-D SDS-PAGE and HTP-chromatography allows the characterization of low abundance phosphoproteins involved in the cellular responses to G-CSF and presumably to other cytokines/growth factors.

Dependence of wool fabric dimensions on temperature and pH

Through a series of experimental analysis of temperature and pH value on the expansion of wool fiber and wool fabrics size change. In the pH2.1 solution, the wool fabric size declines with increasing temperature, changing the magnitude depends on the fabric and fabric shape rate. isoelectric point of pH4.8 in the wool, the fibers expand to reach the minimum, while the size of the fabric, along with the solution acidity increases.

Tensile behaviour of wool fabric as a function of fabric pH

Wool fabric extensibility under a 5 N/cm load was observed to be greatest at the wool isoelectric point of pH 4.8 and lower at both pH 2.1 and pH 7.2. The impact of pH on fabric extensibility is similar to the variation in fabric hygral expansion previously observed. Fabric stress-strain curves at different pHs show that for a given fabric extension level, the work required to stretch a fabric was less at pH 2.1 than at pH 4.8. These results confirm the fact that the strength of wool fabric is at a maximum when the pH of the fibres is close to the isoelectric point.

Formulation optimization for high drug loading colonic drug delivery carrier

High drug loading (DL) carrier is an effective way to cure the cancerous cells. High drug loading is also one of the key issues in the drug delivery research, especially the colonic drug delivery system by oral administration. The times of drug intake could be remarkably reduced if high drug loading carriers are administered. At the same time, the related formulation materials could be effectively utilized. One major obstacle with the preparation of this system is the difficulty to encapsulate the hydrophilic drug into hydrophobic encapsulation polymer. A design of high drug loading delivery system with biodegradable, biocompatible materials and optimization of the fabrication process is a potential solution to solve the problem. So in this research, 5-Fluorouracil (5-FU) loaded Poly (lactide-co-glycolide) (PLGA) nanoparticles were prepared by double emulsion and solvent evaporation method. Several fabrication parameters including theoretical drug loading, volume ratio of outer water phase to the first emulsion, pH value of outer aqueous phase and emulsifier PVA concentration were optimized to get a high drug loading nanoparticles. The result shows that with the increase of theoretical drug loading, the actual drug loading increased gradually. When adjusted the pH value of outer aqueous phase to the isoelectric point (8.02) of 5-Fluorouracil, the drug loading exhibited a higher one compared to other pH value solution. Relative higher volume ratio of outer water phase to the first emulsion was also beneficial for the enhancement of drug loading. But the nanoparticles size increased simultaneously due to the lower shearing force. When increased the PVA concentration, the drug loading showed an increase first and following a drop.

Rapid fibre diameter measurement in aqueous solutions with OFDA 2000

In this paper, a new technique has been developed to enable fibre diameters to be measured in an aqueous environment using the OFDA 2000 instrument. The existing OFDA instrument has only been used to measure diameters of animal fibres under dry conditions. This new technique was utilised to assess the effects of pH and temperature on the diameters of merino wool fibres in aqueous environments. Significant changes in fibre diameter under aqueous conditions were found as a function of pH and temperature. Wool fibre diameters were at a minimum close to the wool isoelectric point (pH 4.8) and increased at both lower and higher pHs. Swelling of merino wool fibres was observed to increase linearly by around 15% as the temperature rose from ambient to 70°C.

Effects of pH on the stress-strain properties of wool fabric

In wool dyeing and finishing processes, fabric is often treated under conditions of different pHs and is subjected to a variety of physical and chemical environments. This work investigates fabric tensile properties at three different fabric pHs. Wool fabric extensibility under a 5 N/cm load was observed to be greatest at the wool isoelectric point of pH 4.8 and lower at both pH 2.1 and pH 7.2. The impact of pH on fabric extensibility was found to be similar to the variation in fabric hygral expansion previously observed. Fabric stress–strain curves at different pHs showed that for a given fabric extension level, the work required to stretch a fabric was less at pH 2.1 than at pH 4.8. These results suggest that the strength of wool fabric is at maximum when the pH of the fibres is close to the wool isoelectric point and that for consistency, the pH of fabric should be adjusted before standard strength tests are carried out.

A parametric study of a monolithic microfluidic system for on-chip biomolecular separation

A microfabricated poly(dimethylsiloxane) (PDMS) chip containing channel filled with polymer monolith has been developed for on-chip biomolecule separation. Methacrylate monolithic polymers were prepared by photo-initiated polymerization within the channel to serve as a continuous stationary phase. The monolithic polymer was functionalized with a weak anion-exchange ligand, and key parameters affecting the binding characteristics of the system were investigated. The total binding capacity was unaffected by the flow rate of the mobile phase but varied significantly with changes in ionic strength and pH of the binding buffer. The binding capacity decreased with increasing buffer ionic strength, and this is due to the limited available binding sites for protein adsorption resulting from cationic shielding effect. Similarly, the binding capacity decreased with decreasing buffer pH towards the isoelectric point of the protein. A protein mixture, BSA and ovalbumin, was used to illustrate the capacity of the methacrylate-based microfluidic chip for rapid biomolecule separation.

Amine enrichment of thin-film composite membranes via low pressure plasma polymerization for antimicrobial adhesion

Thin-film composite membranes, primarily based on poly(amide) (PA) semipermeable materials, are nowadays the dominant technology used in pressure driven water desalination systems. Despite offering superior water permeation and salt selectivity, their surface properties, such as their charge and roughness, cannot be extensively tuned due to the intrinsic fabrication process of the membranes by interfacial polymerization. The alteration of these properties would lead to a better control of the materials surface zeta potential, which is critical to finely tune selectivity and enhance the membrane materials stability when exposed to complex industrial waste streams. Low pressure plasma was employed to introduce amine functionalities onto the PA surface of commercially available thin-film composite (TFC) membranes. Morphological changes after plasma polymerization were analyzed by SEM and AFM, and average surface roughness decreased by 29%. Amine enrichment provided isoelectric point changes from pH 3.7 to 5.2 for 5 to 15 min of plasma polymerization time. Synchrotron FTIR mappings of the amine-modified surface indicated the addition of a discrete 60 nm film to the PA layer. Furthermore, metal affinity was confirmed by the enhanced binding of silver to the modified surface, supported by an increased antimicrobial functionality with demonstrable elimination of E. coli growth. Essential salt rejection was shown minimally compromised for faster polymerization processes. Plasma polymerization is therefore a viable route to producing functional amine enriched thin-film composite PA membrane surfaces.

Widespread convergence in toxin resistance by predictable molecular evolution

The question about whether evolution is unpredictable and stochastic or intermittently constrained along predictable pathways is the subject of a fundamental debate in biology, in which understanding convergent evolution plays a central role. At the molecular level, documented examples of convergence are rare and limited to occurring within specific taxonomic groups. Here we provide evidence of constrained convergent molecular evolution across the metazoan tree of life. We show that resistance to toxic cardiac glycosides produced by plants and bufonid toads is mediated by similar molecular changes to the sodium-potassium-pump (Na(+)/K(+)-ATPase) in insects, amphibians, reptiles, and mammals. In toad-feeding reptiles, resistance is conferred by two point mutations that have evolved convergently on four occasions, whereas evidence of a molecular reversal back to the susceptible state in varanid lizards migrating to toad-free areas suggests that toxin resistance is maladaptive in the absence of selection. Importantly, resistance in all taxa is mediated by replacements of 2 of the 12 amino acids comprising the Na(+)/K(+)-ATPase H1-H2 extracellular domain that constitutes a core part of the cardiac glycoside binding site. We provide mechanistic insight into the basis of resistance by showing that these alterations perturb the interaction between the cardiac glycoside bufalin and the Na(+)/K(+)-ATPase. Thus, similar selection pressures have resulted in convergent evolution of the same molecular solution across the breadth of the animal kingdom, demonstrating how a scarcity of possible solutions to a selective challenge can lead to highly predictable evolutionary responses.